Starting with the upper guide assembly, shift it forward until the two guide bearings (or guide blocks or guide screws, on some saws) sit just behind the gullets. It includes the mounting bracket, bored to 3/4" for most standard tool posts, the thrust bearing that rides behind the blade, and the blade guide fork with 2 cool block style inserts for guiding the blade. Carter Conversion Kit. Editor test-drive: I spent a mere 15 minutes installing the Carter Conversion Kit on my 14" Jet bandsaw. A great alternative if you cannot afford the ball bearing guide set that we sell for these saws. Band saws have a guide that can be moved vertically and they surround the blade. You need to position the upper guide vertically at the correct position relative to the material that you’re cutting. The idea is to get the guide … If the teeth were allowed to … Blade guide for resawing on a 14" bandsaw An alternative to using riser blocks The problem with 14" cast iron framed bandsaws is that the upper blade guide can only be raised 6" (15 cm) above the table. This handy item replaces several problem parts in one complete assembly! The blade runs through this guide. It replaced not only the guides, but also my saw's entire upper and lower blade-guide … This really limits the saw … This is a Upper Left 1 1/2" Band Saw Blade Guide, this guide will fit the following DoAll Machines: TF-24, TF-25 The complete set of 4 will include the following part numbers: 141942, 141943, 141944 and 141945 This Guide Mounts solid on Guide …